What should you pay attention to when using wire rope electric hoist?

The hook of the wire rope electric hoist should be placed under the counterweight for a long time, because the elasticity of the wire rope can remain stable without rewinding under the weight of the hook. Once the hook hits the ground or the weightless cargo during operation, it should be stopped immediately. Operate and visually check whether the wire rope is rewinded. If it is normal, it can continue to be used. Otherwise, the wire rope needs to be adjusted before use. Otherwise, the wire rope in the rope groove will not cooperate with the rope guide properly, causing mutual damage, and then causing an accident. series of failures.

1. The adjustment of the rated power of the wire rope electric hoist motor cannot be done at will and must refer to the structural principles.

2. It is strictly prohibited to use it in harsh natural environments, use it with overload, lift it at an angle or drag heavy objects.

3. The operation of wire rope electric hoist should be standardized. At the same time, it is forbidden to press the corresponding button on I, and other control buttons must not violate the operation. Please follow the instructions

instructions for proper use.

4. The limiter is a type of safety device, so it cannot be used as a switch. It is strictly prohibited to operate without a rope guide or limiter, and the rope must be checked regularly.

guide and limit switch sensitivity.

5. When the wire rope electric hoist is not in use, make sure that no heavier objects are floating in the air. If you don't do that, the parts will deform.

6. For wire rope electric hoists, leave a gap of 3-5mm between the edge of the traveling wheel and the track. If there is any deviation, please use the washers of the bolts to adjust the

Make adjustments.

7. Before using the wire rope electric hoist, add or apply lubrication to the parts that need lubrication according to the lubricating parts and lubrication methods described in the manual.

Just the right amount of lubricant. After the electric hoist is installed, lubricating oil should be injected into the reducer according to the lubricating oil capacitance meter, and the driving device should be injected with calcium-based grease.